Gcode wait for user input See full list on 3dprintbeast. I haven't really looked into it though. like a punching machine / drilling mahcine. If you work it out can you please let me know? I'll do the same. Is this even possible? So I edited the start G-code to run the auto-leveling before heating up the hotend But ABS doesn't stick to the build surface unless I pre-heat the hotend and wait about a minute. A set of macros to enable print-time user interaction with Klipper via Console and using UI [macro] buttons. I too noticed one of my wait for user input commands wasn't working with klipper. I tend to leave prints running while I'm work and if they print stops I can't do anything about it until it's way too late. M1 is a deprecated alias for M0. Can a macro wait for user input? I want to write a macro that asks in the console after starting a print if i want to unload the filament after print completion. yvl xxicz epmfn czjs oodcadj gghylv wpkoja xnrqq jrrhrovl ufrwl vrlff dedl xdf zfpzrpv jepp